Advertisement
10. REAR CURTAIN
If installing a hard rear panel, skip this step and continue
with step 11 below.
10.1 Assemble the six (6) snaps on the rear curtain to
the six (6) snaps on the back side of the roof.
10.2 Dry fit the sides of the rear curtain to the wide in-
ner surface of the side frame rear vertical tubing as
shown in fig. 10.2. Install the supplied 1" wide hook vel-
cro to a clean, dry surface at room temperature for best
adhesion. Attach the curtain to the newly installed velcro.
11. UNDER SEAT FILLER
11.1 Per fig. 11.1, tip/raise the seat forward and position
the under seat vinyl filler as shown with the seat belt
bracket passing through the slit openings on each side.
Dry fit this and estimate where to apply the supplied 1"
wide hook velcro to the fenders, etc.. Reminder: for best
adhesion, apply self-adhesive backed velcro to clean, dry
surfaces at room temperature. The top middle section of
the under seat filler attaches to the bottom of the soft rear
curtain or to the bottom inside surface of a hard rear pan-
el as shown in fig. 11.1.1. For the hard rear panel, install
more of the supplied 1" wide velcro to suit.
2" wide inner surface
of side frame rear
vertical tube
Fig. 10.2 (view from center of tractor)
Fig. 11.1 (view from left side of tractor)
Fig. 11.1.1 (view from left side of tractor)
p. 8 of 12
seat belt
bracket
opening
hard rear panel
is shown here
Advertisement
