Advertisement
13. TURN SIGNAL LIGHTS
13.1 Per fig. 13.1, re-install the turn signal light to the
welded bracket on the back side of the side frames. Use
the supplied wires to connect to the existing wiring un-
derneath the fender (see fig. 13.1.1). Repeat for opposite
side.
14. WINDSHIELD WIPER
14.1 Install the wiper motor per the installation instruc-
tions included with the wiper kit.
15. FINISHING TOUCHES
15.1 Peel protective film from the windows.
15.2 Install the supplied nut covers on the interior lock-
nuts (qty.: 20).
16. CARE AND MAINTENANCE
16.1
Once the doors are properly adjusted, lubrication
(preferably grease) can be applied to the striker bolts and
door latch assemblies. Re-apply periodically as needed
(same goes for the door pin hinges as necessary).
16.2
Check and tighten hardware after 40 hours of op-
eration. Periodically inspect and tighten hardware for the
remainder of the unit's life.
16.3
Wash the painted surfaces of the unit with com-
mercial automotive cleaning products.
16.4
Clean windows with glass cleaner.
16.5
Vinyl components should be washed with a mild
solution of warm soapy water.
16.6
Clear vinyl can be easily scratched. Be careful
cleaning frost or snow from rear curtain. Do not roll cur-
tain in cold weather. The curtain becomes stiff and may
crack. Keep curtain clean.
both washers and nut on this side
Fig. 13.1 (view from rear left side of tractor)
connect wires
Fig. 13.1.1 (view from rear right side of tractor)
p. 10 of 12
Advertisement
