Advertisement
6. WINDSHIELD SUPPORT
6.1 See fig. 6.1. With assistance, install the windshield
support to the top front corner of the side frames oriented
as shown with the bent flanges on the bottom. In the low-
er holes only, use the following hardware per side frame:
one 5/16 x 1" long button head bolt, one steel washer,
one nylon washer, and one locknut. Refer to the helpful
hints section on page two for the proper placement of the
nylon washer. Do not tighten bolts. Note: the upper hole
on each side will get hardware once the roof is installed.
7. WINDSHIELD
7.1
See fig. 7.1. Have the following items ready: four
5/16 x 1-3/4" long flat head bolts, four locknuts, and two
plastic spacer blocks. With assistance, install the wind-
shield hinges to the windshield support with the two
spacer blocks between the hinge and the windshield sup-
port. Attach windshield latches to windshield latch re-
ceivers on the cowl by squeezing tabs to retract spring
loaded pins. See fig. 7.1.1. Lift up on bottom of wind-
shield and close latches. Check alignment of windshield
with side frames and tighten hinge hardware. CAU-
TION: hinges are plastic components. Do not over-
tighten hardware. Torque to 7 foot-pounds maxi-
mum. Also tighten both lower windshield support bolts
(from step 6 above).
leave empty for now
install
bolt
here
Fig. 6.1 (view from front left side of tractor)
3/4" thick spacer block
Fig. 7.1 (view from front right side of tractor)
latch
receiver
Fig. 7.1.1 (view from center of tractor)
p. 6 of 12
Advertisement
