Advertisement
5.
SIDE FRAME (cont'd.)
5.2 Per fig. 5.2, use the following hardware installed
horizontally into the front of the side frame tubing (into
factory installed threaded inserts): three 5/16 x 3/4" long
button head bolts, three nylon washers, and three steel
washers. See helpful hint "D" on page 2 for proper place-
ment of nylon/plastic washers. Use caution to avoid
damaging the factory installed threaded inserts. Begin the
bolt engagement by hand to avoid or correct potential
cross-threading. Do not tighten bolts.
5.3 Per fig. 5.3, clamp the top corner of the cowl to the
side frame to assist in lining up the holes for the vertical
bolt. Use the following hardware in this location: one
5/16 x 3/4" long button head bolt, one steel washer, and
one locknut. The head of the bolt is to be up top as
shown. Tighten bolt and remove clamp.
5.4 Per fig. 5.4, attach the back side of the side frame to
the roll bar bracket assembly. Note: fig. 5.4 shows an
optional hard rear panel in place. Use the following hard-
ware in each of the four roll bar bracket assemblies: one
5/16 x 1" long button head bolt, one nylon washer, and
one steel washer. Thread into the factory installed thread-
ed inserts in the rear of the side frame tubing. Do not
tighten bolts.
5.5 For the remaining two threaded inserts per side
(one up top and one down bottom) on the back of the side
frame, leave them open if not installing a hard rear panel.
If installing a hard rear panel, use the following hardware
per side: two 5/16 x 3/4" long button head bolts, two ny-
lon washers, and two steel washers. Thread into the fac-
tory installed threaded inserts in the rear of the side frame
tubing. Do not tighten bolts.
5.6 Repeat all of section 5 for the opposite side frame.
5.7 Per fig. 5.7, new decals can be obtained from
Kubota and repositioned on the tractor if required.
Fig. 5.7 (view from center of tractor)
install
bolts
here
Fig. 5.2 (view from front left side of tractor)
head of vertical bolt
Fig. 5.3 (view from front right side of tractor)
nylon washer, steel
washer, head of bolt
Fig. 5.4 (view from rear right side of tractor)
p. 5 of 12
clamp here
hard rear
panel
Advertisement
