Advertisement
1. VEHICLE PREP
1.1 Per fig. 1.1, remove the following five (5) items
from the tractor: the optional tool box and clamps from
the roll bar (if equipped), both grab handles, and both
turn signal lights from the fenders (identify the wires for
easier re-connection later). Save the turn signal lights,
washers, and nuts for re-use in step 13.
2. ROLL BAR BRACKETS
2.1 Per fig. 2.1, loosely install the roll bar brackets and
the roll bar mounts to the R.O.P.S. tubing (two places per
upright) (approximately where shown in relationship to
the removable pin for the fold-down R.O.P.S.. Ref.: the
center of the bolt hole should be approximately 14-1/2"
up from the fender and 36-1/2" up from the fender. When
left loose, these units will be able to slide up or down to
match the exact mounting holes in the back of the side
frames. Orient as shown for the right side and opposite
for the left side. Use the following hardware per setup:
one 5/16" x 1" long carriage bolt and one locknut. The
locknut is to be towards the outside of the tractor.
Fig. 1.1 (remove these items from tractor)
14-1/2" up from fender
Fig. 2.1 (roll bar bracket on right side of vehicle)
p. 3 of 12
locknut here
(outboard)
Advertisement
