Install Converters
Step
Action
Connect your personal ESD strap to the ESD jack on the left of a converter shelf before removing the Converters
from their anti-static wrap:
1.
2.
Remove the Converter from its shipping container.
Install the Converter into the Shelf.
1.
Align the plastic converter housing on the right with the card guides at the top and bottom of the slot.
2.
Slide the converter into the slot.
3.
Push firmly seat the converter until the converter latch engages.
3.
4.
Repeat from Step 2 for remaining Converters.
5.
Install empty slot fillers into all unused slots of multi-shelf Converter Shelf Stacks.
Apply DC Power
Fault LEDs will flash red until communications is established between the system components. – see
Verify Normal States for details.
Step
Action
Apply DC power by turning on circuit breakers and inserting fuses feeding both Fan Shelves and the Converter
1.
Shelves.
Page 27
© Copyright 2021 ABB. All rights reserved.
ESD
Thumb-Latch
ESD Jack