Electrical Information - Impax IM-MULT160-K Instruction Manual

ELECTRICAL INFORMATION

WARNING! THIS APPLIANCE MUST BE
EARTHED
Models Fitted With 13A Plug
Welders fitted with a standard 13 amp BS 1363
plug, should be connected to a to a 230 volt
(50Hz) domestic electrical supply and we
strongly recommend that this be done via a
Residual Current Device (RCD).
IMPORTANT: If the welder is fitted with a plug
which is moulded onto the electric cable (i.e.
non- re-wirable) please note:
1. The plug must be thrown away if it is cut
from the electric cable. There is a danger of
electric shock if it is subsequently inserted
into a socket outlet.
2. Never use the plug without the fuse cover
fitted.
3. Should you wish to replace a detachable fuse
carrier, ensure that the correct replacement is
used (as indicated by marking or colour
code). Replacement fuse covers can be
obtained from your local dealer or most
electrical stockists.
Fuse Rating
The fuse in the plug must be replaced with one
of the same rating (13 amps) and this
replacement must be ASTA approved to
BS1362.
Technical specification
Input power:
Rated input capacity:
Output current range:
Output current range:
Output current range:
Rated duty cycle:
No-load voltage:
Efficiency:
230V~50Hz
6.1kVA
10-140A (MMA)
10-140A (TIG)
35-160A (MIG)
11-26V (MIG)
20%
U : 62V, U : 9.5V
0 r
85%
18
Models Fitted Without Plug
230V Supply
Connect the mains lead to a suitably fused 230
Volt (50Hz) electrical supply. The fuse rating
should correspond to that shown on the
technical specification on page 19.
The wires in the mains lead are coloured in
accordance with the following code:
Green & Yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the flexible cord of this
appliance may not correspond with the coloured
markings identifying terminals in your plug,
proceed as follows:
• Connect GREEN & YELLOW cord to plug
terminal marked with a letter "E" or Earth
symbol " ", or coloured GREEN or GREEN
& YELLOW.
• Connect BROWN cord to plug terminal
marked letter "L " or coloured RED.
• Connect BLUE cord to plug terminal marked
letter "N" or coloured BLACK.
Case protection class:
Power factor:
Insulation grade:
Cooling type:
Fuse:
External dimensions:
Weight:
Applicable electrode:
IP21S
0.70 cosφ
F
Fan cooling
16A
553 x 214 x 388mm
12kg
1.6~4.0mm
0.6/0.8/0.9/1.0mm