Table of Contents
Advertisement
WARNINGS
Make sure that the arrows on
directional tires (where fitted), point
in the direction of rotation when the
vehicle is moving forwards. If you have to
fit a spare wheel with the arrows pointing
in the opposite direction, have the tire
refitted in the correct direction by a
properly trained technician.
1.
Insert the flat end of the wheel brace
between the rim and the wheel trim
and carefully remove the wheel trim.
2. Install the locking wheel nut key.
3. Slacken the wheel nuts.
4. Jack up your vehicle until the tire is
clear of the ground.
5. Remove the wheel nuts and the wheel.
Installing a Road Wheel
WARNINGS
Make sure that the arrows on
directional tires point in the direction
of rotation when your vehicle is
moving forward. If you have to fit a spare
wheel with the arrows pointing in the
opposite direction, have the tire refitted in
the correct direction by an authorized
dealer.
Use only approved wheel and tire
sizes. Using other sizes could
damage your vehicle and will make
the National Type Approval invalid.
Do not fit run flat tires on vehicles
that were not originally fitted with
them. See an authorized dealer for
more details about compatibility.
WARNINGS
Do not install alloy wheels using
wheel nuts designed for use with
steel wheels.
Tourneo Custom/Transit Custom (TTF) Vehicles Built From: 01-09-2013, enAUS, Edition date: 12/2014
Wheels and Tires
wheels supplied for your vehicle. If in doubt
see an authorized dealer.
nuts.
Note: The wheel nuts of alloy wheels and
spoked steel wheels can also be used for
the steel spare wheel for a short time
(maximum two weeks).
Note: Make sure the wheel and hub contact
surfaces are free from foreign matter.
Note: Make sure that the cones on the
wheel nuts are against the wheel.
1.
2. Install the wheel nuts finger tight.
3. Install the locking wheel nut key.
E154985
4. Partially tighten the wheel nuts in the
5. Lower your vehicle and remove the
6. Fully tighten the wheel nuts in the
140
WARNINGS
Wheel nuts are subject to change.
You must make sure that you use
only the specific wheel nuts and
Make sure that there is no lubrication
(grease or oil) on the threads or the
interface between wheel studs and
Install the wheel.
1
3
5
sequence shown.
jack.
sequence shown.
4
2
Advertisement
Table of Contents
