Limb Set Up - endolite Smart IP System SMARTIPSFPYR Fitting Instructions

Limb Set Up

Adjust for static alignment as shown in the ESK+ fitting instructions supplied with the module.
Cushion Valve adjustment - If after programming for the first time, the user experiences too much or too little damping at the end of the swing, the cushion valve may be
adjusted. Fine Tuning MUST always follow any cushion valve adjustment.
Smart IP operation Smart IP operation
Initial Set Up, first time use Initial Set Up, first time use
START
Fully Fully Fully Fully
extend extend flex flex
Calibrate Limb Calibrate Limb to User
& enter Program mode & enter Program mode
Approx. 12m (40') required
Programming Programming
vary speed gradually for approx. 200 steps vary speed gradually for approx. 200 steps
Prosthetist Fine Tuning
START
Fully Fully Fully Fully
extend extend flex flex extend extend
maximum 4 seconds
vary speed gradually for approx. 200 steps vary speed gradually for approx. 200 steps
User Fine Tuning
(repeat 'Prosthetist Fine Tuning')
START
vary speed gradually for approx. 200 steps
refrain from sitting during programming
Fully Fully Fully Fully
extend extend flex flex extend extend
maximum 6 seconds
UNTIL
refrain from sitting during programming refrain from sitting during programming
Fully Fully Fully Fully Fully Fully
flex flex extend extend
refrain from sitting during programming refrain from sitting during programming
2 secs
x2 x2
4 secs
Save & Exit Save & Exit
HOLD
Flex to greater than 40°
Fully Fully Fully Fully Fully Fully
flex flex extend extend
x1
STOP
2 secs 2 secs
x2 x2
HOLD HOLD
Walk at various speeds to ensure user
x2 x2
40° +
Fully
extend
2 secs 2 secs
x3 x3
HOLD HOLD
4 secs
Save
& Exit
HOLD
Flex more than 40°
4 secs
Save
& Exit
HOLD
Flex more than 40°
is completely satisfied.
x2
Fully
extend
x2
Fully
extend
END