Wiring The Fault Alarm Contact - LevelOne IFE-0501 User Manual

4-port poe + 1-port sc industrial fast ethernet switch

Hide thumbs Also See for IFE-0501:

Table of Contents

Wiring the Fault Alarm Contact

The fault alarm contact is in the middle of terminal block connector as the picture

shows below. When the wires are inserted into ports 3 and 4, they automatically

detect the fault status in the event of a power failure by forming an open circuit.

An example for the fault alarm contact is shown as below:

Insert the wires into the fault alarm contact.

The wire gauge for the terminal block should be in the range

between 12 ~ 24 AWG.

Table of Contents

Ife-0502