Table of Contents
Advertisement
INSTALLATION AND CONNECTION
SELECTING THE ROOM
• Install the appliance in a dry and well ventilated room. Ambient temperature should never be lower than
41 °F.
Warning: Make sure the room where the appliance is installed is large enough. There should be at
least 1 m
of space per 8 grams of refrigerant. Amount of refrigerant is stated on the rating plate in the
3
appliance interior.
INSTALLING THE APPLIANCE
Appliance installation should be carried out by
at least two persons to avoid any physical injury
or damage to the appliance.
• The appliance must stand level or tilted
>
slightly to the back, stable on a solid base. At
9
0
°
the front, the appliance is fitted with two
max
30 mm
adjustable legs that can be used to level the
appliance. At the rear side, casters allow for
easier installation of the appliance (only with
some models).
• There should be a clearance of at least 5 cm
between the appliance and any cupboard
installed above it, to allow adequate cooling of
the condenser unit.
• The appliance is supplied with two spacers
which should be installed on the lower part
of the housing to prevent from pushing the
appliance too close to the wall. Appliance
may also be installed without the spacers;
however, this may increase power
consumption.
• Do not expose the appliance to direct
sunlight and do not place it near any source
of heat. If this cannot be avoided, install an
insulation panel.
9
Advertisement
Table of Contents
