Chapter 2. Connecting The Router; System Requirements; Installation Environment Requirements; Connecting The Router - TP-Link TL-MR3420 User Manual

Chapter 2. Connecting the Router

2.1 System Requirements

Broadband Internet Access Service (DSL/Cable/Ethernet)

One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the router is

connected directly to the Ethernet.)
PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors

TCP/IP protocol on each PC

Web browser, such as Microsoft Internet Explorer 5.0 , Netscape Navigator 6.0 or above


2.2 Installation Environment Requirements

Place the router in a well ventilated place far from any heater or heating vent.

Avoid direct irradiation of any strong light (such as sunlight).

Keep at least 2 inches (5 cm) of clear space around the router.

Operating Temperature: 0℃~40℃ (32℉~104℉).

Operating Humidity: 10%~90%RH, Non-condensing.


2.3 Connecting the Router

Before installing the router, make sure your PC is connected to the Internet through the
broadband service successfully. If there is any problem, please contact your ISP. After that,
please install the router according to the following steps. Don't forget to pull out the power plug
and keep your hands dry.
1. Power off your Cable/DSL Modem, and the router.
2. Locate an optimum location for the router. The best place is usually at the center of your
wireless network. The place must accord with the
3. Adjust the direction of the antenna. Normally, upright is a good direction.
4. Connect the PC(s) or Switch/Hub in your LAN to the LAN Ports of the 3G/4G router with
Ethernet cable.
5. The 3G/4G router supports both 3G/4G and WAN connection; so you can insert 3G/4G
USB Modem to the USB port of the router, or connect the DSL/Cable Modem to the WAN
port of the router. Please visit our website http://www.tp-link.com to get the latest USB
modems compatibility, and we recommend you to check whether the modem in your hand
has already been tested by us.
6. Connect the power adapter to the power socket on the router, and the other end into an
electrical outlet. The router will start to work automatically.
7. Power on your Cable/DSL Modem.
TL-MR3420 3G/4G Wireles N Router User Guide
Installation Environment
-5-
Requirements.