Connecting The Router - TP-Link MR0-W8901G User Manual

Keep away from the strong electromagnetic radiation and the device of electromagnetic
sensitive.

2.4 Connecting the Router

Before installing the device, please make sure your broadband service provided by your ISP is
available. If there is any problem, please contact your ISP. Before cable connection, cut off the
power supply and keep your hands dry. You can follow the steps below to install it.
Step 1: Connect the ADSL Line.
Method one: Plug one end of the twisted-pair ADSL cable into the ADSL LINE port on
the rear panel of MR0-W8901G, and insert the other end into the wall socket.
Method two You can use a separate splitter. External splitter can divide the data and
voice, and then you can access the Internet and make calls at the same time. The
external splitter has three ports:
LINE: Connect to the wall jack
PHONE: Connect to the phone sets
MODEM: Connect to the ADSL LINE port of MR0-W8901G
Plug one end of the twisted-pair ADSL cable into the ADSL LINE port on the rear panel
of MR0-W8901G. Connect the other end to the MODEM port of the external splitter.
Step 2: Connect the Ethernet cable. Attach one end of a network cable to your computer's
Ethernet port or a regular hub/switch port, and the other end to the LAN port on the
MR0-W8901G.
Step 3: Power on the computers and LAN devices.
Step 4: Attach the power adapter. Connect the power adapter to the power connector on the rear
of the device and plug in the adapter to a wall outlet or power extension.
MR0-W8901G 54M Wireless ADSL2+ Router User Guide
5