Table of Contents
Advertisement
If you make a mistake, you can cycle through the digits by pressing [MODE] and then
using [Y/+] and [N/-] to change the number in each position.
Note:The default password is 0000.
If your password is incorrect, you see this screen:
After a few seconds, the Mesh Router exits to its main screen.
When you have successfully entered Programming Mode, you see this screen:
Note:If you do not make a selection in 60 seconds, the Mesh Router automatically exits
to the main screen.
Press [Y/+] or [N/-] to scroll to "Settings," "Wireless," or "Exit." Then press [MODE] to
select your choice.
Settings provides information about your instrument. Some screens are read-only (you
cannot edit them), but other screens allow you to change settings.
Mesh Router
32
User Manual
Advertisement
Table of Contents
