Thermo Scientific TSE Series Operating And Maintenance Manual page 9

Section 1
Installation and Start-Up
1-2 TSE Series
Wall Bumper
(pre-tapped holes)
Remote Alarm
Contacts
Figure 1-2. Freezer Rear View Components
• Remote alarm contacts
• Power inlet for power cord connection
• Optional BUS connections for probe and solenoid
• Power switch (mains disconnect)
Shelf
bracket
Sensor sealant
CAUTION: This is critical seal.
Seal must be maintained.
Figure 1-3. Chamber Probe(s)
Optional Back-up
System Connections
Power Switch
(mains
disconnect)
Power Inlet
Optional recorder /
datalogger probe
Control RTD/Redundant
Type T Thermocouple probe
Performance Alarm Monitor
and Temperature Probes.
PT100 sensor
Optional PT1000 3m long -
calibration probe additional
Thermo Scientific Thermo Scientific