Table of Contents
Advertisement
INSTALLATION ON UNDER-PLASTER OR SURFACE-MOUNTED ELECTRICAL JUNCTION BOX
CONNECTING POWER SUPPLY AND CONTROL CABLES
3.3. Installation in the working position
The regulator is mounted on the wall in the vertical position – the side vents are facing down and up.
-
The regulator shall be installed in such a way that air can flow around and the overheating is avoided.
-
The regulator installation must be carried out in a place where sufficient and safe access will be provided
-
in the event of control, maintenance, servicing.
The regulator must be mounted in such a way that the minimum spacing distances of 100 mm from all
-
constructional structures and flammable substances or the distances based on local regulations are
respected.
3.4. Electrical installation and electrical connection
-
The regulator may be connected only by persons qualified to handle electrical devices up to 1000V. The
regulator mounting shall be in accordance with the relevant standards. The regulator must be
connected to the EC-motor using an insulated cable in accordance with the diameter and corresponding
regulations.
In the event of fire, the regulator must be extinguished with CO2 or a powder-type fire extinguisher.
-
Technical parameters
4.
Input voltage
-
Input current
-
Max.ambient temperature
-
Protection
-
Weight
-
Verze 1 – GBR (11.3.2020)
COMPLETING THE CONTROL PANEL AFTER CONNECTING
(ALIGN THE CABLES TO AVOID DAMAGE)
10VDC
10mA
5-35°C
IP20
0,12Kg
5
D-502-0168
Advertisement
Table of Contents
