Gainsborough K846 Instructions For Use

Set 4 Solar Up & Down Fence Lights
K846
v001: 13/05/22
Please read and retain these instructions for future reference
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed
from the packaging.
Before using first time
Allow lamp to charge for at least 8 hours in full sunlight with the ON/OFF switch
in the ON position. The ON/OFF switch is usually located below or next to the
solar panel. Once the batteries are fully charged, set the ON/OFF switch to ON. If
the lamp does not turn on after dark refer to Maintenance section.
Find an ideal Place for the Solar Light.
Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of
hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed
in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the
light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from
coming on, or cause it to turn off automatically
Installation
The Enterprise
Department
Dimensions
(H) 10 x (W) 7.3 x (D) 3cm
•
EACH SOLAR LIGHT HAS 2 WARM WHITE SMD LED'S (NOT
REPLACEABLE) AND INTEGRAL SOLAR PANEL
•
NO MESSY OR TRAILING WIRES
•
COMES WITH WALL FIXINGS
•
AUTOMATICALLY ILLUMINATES AT NIGHT
•
PLACE IN A SUNNY SPOT
•
LIGHT A WALL, FENCE OR SOME STAIRS
Required: 1x AA 1.2V 400mAh Ni-Mh battery per light (included) (not
replaceable)
UK Head Office, 11 Bridge Street, Bishop's Stortford, CM23 2JU
Tel: 0844 4824400*, Fax: 01279 756595
www.coopersofstortford.co.uk
EU address: D.S.B. LD, 160 Bd. de Fourmies, 59100 Roubaix, France
Tel: (+44) 1279 701269
*UK Calls cost around 7 pence per minute plus your telephone company's network access.
Please check with your telephone supplier.
ALWAYS POSITION IN DIRECT SUNLIGHT