Jumper Connections; Recommended Operating Conditions - Texas Instruments bq24 9 Series User Manual

www.ti.com
Table 3 lists the controls and key parameter settings for this EVM.
Jack Description
JP1 For bq24190/2/2i/3/6 and bq24292i input current setting:
PSEL LOW: Adaptor input
PSEL HIGH: USB input
JP2 D-/PG pin selection
JP3 STAT, PG, /CE, INT, OTG pin internal pull-up source (VSYS) jumper
JP4 USB current limit selection pin during buck mode and PSEL is high (JP1- Not installed
High)/Enable pin during boost mode.
In buck mode: OTG = High, IIN limit = 500 mA;
OTG = Low, IIN limit = 100 mA.
The boost mode is activated when the REG01[5:4] = 10 and OTG pin is
HIGH.
JP5 CE pin setting: pull low to enable the charge
JP6 For bq24190 input current limit setting:
JP7 TS1 resistor divider pull-up source (REGN) connection
JP8 internal 10k to ground to TS1
JP9 internal 10k to ground to TS2
JP10 TS2 pin setting:
Table 4 lists the recommended operating conditions for this EVM.
Symbol
Supply voltage, V
Battery voltage, V
Supply current, I
Output current, I
Operating junction temperature
range, T
J
SLUUA14C – October 2012 – Revised August 2013
Submit Documentation Feedback
Table 3. Jumper Connections
Table 4. Recommended Operating Conditions
Description
Input voltage from AC adapter
IN
Voltage applied at V
BAT
Maximum input current from AC adapter
AC
input
Output current
OUT
Copyright © 2012–2013, Texas Instruments Incorporated
Factory Setting
bq24190: Not installed
bq24192/2i/3/6 and bq24292i :
Short PSEL to LOW
Bq24190: Short D-/PG to D-
bq24192/2i/3/6 and bq24292i :
Short D-/PG to PG
Installed
Not Installed
(GUI also can pull /CE low)
bq24190: installed
bq24192/2i/3/6 and bq24292i :
Not installed
Installed
Installed
Installed
bq24193: Short TS2 and TS1
bq24190/2/2i/6 and bq24292i: Short
TS2 and TS2-I
MIN
3.9
terminal 0
BAT
0
0
0
bq24190/2/2i/3/6 and bq24292i EVM (PWR021) User's Guide
Introduction
TYP MAX Unit
5/12 17 VDC
3.7 4.25 VDC
3 A
4 A
125 °C
3