Necessary Repairing Tools; Lubricant And Adhesive Application - Makita DTD170 Technical Information

2 CAUTION
Repair the machine in accordance with "Instruction manual" or "Safety instructions".
Follow the instructions described below in advance before repairing:
Wear gloves.
·
In order to avoid wrong reassembly, draw or write down where and how the parts are assembled, and what are the parts.
·
It is also recommended to have boxes ready to keep disassembled parts by group.
Handle the disassembled parts carefully. Clean and wash them properly.
·
3

NECESSARY REPAIRING TOOLS

Code No.
1R003 Retaining ring S pliers ST-2N
1R016 1/4" Hex shank bit M6
1R040 Armature holder 50 set for use with Vise
1R045 Gear extractor (large)
1R212-A Tip for retaining ring pliers
1R212-B Plate set (with screws)
1R223 Torque wrench shaft 20-90N·m
1R224 Ratchet head 12.7
1R232 Pipe 30
1R263 Bearing extractor
1R288 Screwdriver magnetizer
1R402-A Digital tester
- Socket 30-78
- Socket 32-50
- Nut spinner handle (Square drive: 12.7 mm)
4

LUBRICANT AND ADHESIVE APPLICATION

Apply the following lubricants and adhesives.
Lubricant
Makita grease FA. No.2
Mixture of Makita Grease FA No.2 (90%) and
Molybdenum disulfide (10%)
Description
Amount
a little
a little
Fig. 4-1
Hole on Anvil
Surface of Anvil Inner groove on
Hammer
3 / 19
Use for
removing Ring spring 11
removing Rotor
removing / assembling Hammer case complete
disassembling Hammer section
use with 1R003
assembling Hammer case complete
use with 1R223
removing Bit sleeve
removing Rotor
removing Steel balls
diagnosing Controller
use with 1R223 and Nut spinner handle in order to remove/
assemble Hammer case complete
removing/ assembling Hammer case complete
removing Hammer case complete
Gear portion: 2g
Contact surface
with Steel ball 3.5
Flat washer 24 Drum portion on
Spindle