SRC R-HM18-27-01-R Quick Start Manual page 4

Step – 2
Insert the Stack plates (2) through, as shown and assemble the Wedge (6) and Buffer plates (4) – 2 off on
top and bottom, and tighten the M5 Nut to each of the Screws as shown.
The bracket as assembled Off-line can be taken to the Motorbike and mounted using (10) & (11) M6
Washer and M6 x 16 Hexagonal Socket head cap screws.
Insert the Rubber Pads – 2 off (9) as a padding to the bottom side of the bracket and this will ensure it is
not fouling / scoring / or damaging the Motorbike bracket.
Copyright By SRC
Design and Specification are subjected to change
Page 4