Table of Contents
Advertisement
Connecting to Power
When connecting the stereo to power, you should connect it through the ignition or another manual switch.
If it is necessary to extend the power and ground wires, use 14 AWG (2.08 mm
than 1 m (3 ft.), use 12 AWG (3.31 mm
1 Route the red power wire
to the battery.
2 If necessary, route a wire
3 Route the wiring-harness plug to the stereo.
Do not connect the wiring harness to the stereo until after all of the bare wire connections have been made.
4 Connect the black wire to the negative (-) battery terminal.
5 Connect the red power wire to the ignition or another manual switch, and connect the switch to the positive
(+) battery terminal if necessary.
6 Connect the wiring harness plug to the stereo.
Speaker Zones
You can group speakers in one area into speaker zones. This enables you to control the audio level of the zones
individually. For example, you could make the audio quieter in the cabin and louder on deck.
You can set the balance, volume limit, subwoofer level, and name for each zone.
8
2
) wire.
to the ignition or another manual switch
between the switch and the battery .
2
) wire. For extensions longer
, and route the black ground wire
Advertisement
Table of Contents
