Table of Contents
Advertisement
1. General information
1.1. Introduction
-
This document "Installation and Operating Manual" is intended for the heating unit Atacama
(hereinafter referred to as the "Unit") used to heat the required space by warm air. Detailed
familiarisation with this document is important for correct and safe installation and functioning of the unit.
Failure to follow the conditions in this document may result in malfunction of the unit.
-
The assembly and connection of the unit may only be carried out by a trained person with the
appropriate authorization to connect electrical equipment, which has suitable tools and means
available. During the assembly, it is necessary to observe all the instructions and recommendations in
this manual.
-
For the correct operation and long-term service life of the unit, it is necessary to prevent access to
unauthorised persons and to train operators according to this document and applicable legislative
regulations.
-
The documentation must always be available at the place of installation for any service intervention. It
is forbidden to interfere in any way with the internal connection of the unit, which does not correspond to
the instructions given in this manual. Due to the continuous development of our products, we reserve the
right to change this manual without prior notice.
1.2. Use of the unit
-
The Atacama heating unit is designed to heat and filter air in the indoor environment (it is possible to
order filters as accessories) of industrial halls, warehouses, sports facilities, workshops and smaller
facilities.
-
The unit is intended for indoor and dry spaces with ambient temperatures from 5°C to +40°C.
-
The unit can also be used for environments with a higher non-condensing humidity corresponding to
the protection levels IP54 and IP44 according to EN 60529, depending on the type of unit. The unit may
also be used in corrosion environment C2, according to EN ISO 9223. The unit must not be operated in
environments with a risk of explosion and increased dustiness.
-
Neither the manufacturer nor the supplier is liable for damage caused by improper use of the units.
The risk is borne by the user alone.
-
The unit must not be operated during finishing construction activities, especially during activities that
create excessive dustiness, e.g. by grinding concrete, plasterboard, etc...
1.3. Transport, inspection of delivery and storage
-
Before starting the installation and before unpacking the unit from the box, it is necessary to check for
any traces of damage on the packaging. In case of damage to the packaging, please contact your carrier.
-
Check if the product ordered by you is in agreement. After unpacking, check that the unit and other
components are intact. Please report any non-conformity with the order to the supplier immediately. If an
order complaint is not made immediately after delivery, it will not be taken into account later.
-
If you do not install the unit immediately after purchase, it must be stored in an indoor, non-
condensing environment at temperatures in the range of 5 to 40°C. If the product has been transported at
temperatures below 5°C, it must be stored after unpacking for at least 2 hours in the working environment
where it will be installed.
-
Use adequate tools to prevent damage to the goods and to avoid health and safety risks of persons.
Verze 1 – GBR (11.3.2020)
4
D-502-0165
Advertisement
Table of Contents
