Operating Your Stf Camera With Maxim Lt; Connecting The Stf Camera To Maxim Lt - SBIG STF Series User Manual

2 - Operating your SBIG STF camera with MaxIm LT
The MaxIm LT application allows full configuration and control of the SBIG
STF cameras and filter wheel. Calibrating files, automating imaging sequences,
logging, and various image processing tasks can all be performed. Please note
however that since MaxIm LT and MaxIm DL both share the same Help file, not
all features detailed in that file will be enabled in MaxIm LT. Full feature
access requires MaxIm DL Pro.
The procedures in this chapter are intended as a basic introduction to
connecting and operating the STF hardware. Consult the Help file for further
information on specific parameters, detailed procedures, and various tutorials.

2.1 Connecting the STF Camera to MaxIm LT

The following is the basic MaxIm LT procedure used to configure and connect
to the STF camera and an optional FW8-8300 filter wheel.
1. Launch the MaxIm LT application.
2. Click the Camera Control icon
Control form and click the Setup tab.
3. Click the Setup Camera button under Camera 1 to open the Setup form.
SBIG STF SERIES - CAMERA USER'S MANUAL
or press Ctrl-W to open the Camera
18