Handlebar Switches - Yamaha Super Tenere ABS XT1200Z 2019 Owner's Manual

Instrument and control functions

Handlebar switches

Left
2
1
6
5
3
4
1. Menu switch "MENU"
2. Select switch "
3. Cruise control switches
4. Horn switch "
5. Turn signal switch "
6. Dimmer/Pass switch "
Right
2
3
1. Stop/Run/Start switch "
2. Drive mode switch "MODE"
3. Hazard switch "
Dimmer/Pass switch "
Set this switch to "
beam and to "
To flash the high beam, press the
switch down to "PASS" while the
headlights are on low beam.
TIP
When the switch is set to low beam,
both headlights come on.
EAU1234M
/ "
"
/ "
/ /PASS"
1
/ / "
"
EAUM4031
/ /PASS"
" for the high
" for the low beam.
When the switch is set to high beam,
both headlights come on.
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
3
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter,
set this switch to "
the switch down towards " ". See
page 5-2 for starting instructions prior
to starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
3-20
/ "
". To signal a left-hand
". When
"
/ / "
", and then push
" to stop the en-
" posi-
EAU12461
EAU12501
EAU54212
EAU12735