cNODE Modem MiniS LF Instruction Manual
5
Cut the Molex plug.
6
Use a wrench to remove the connector.
Use a wrench with a slim 20 mm socket. The outer diameter of the socket should be
24 mm or less to avoid damaging the transponder housing.
7
Clean the threads in the transponder housing.
8
Feed the wires on the new connector through the connector hole.
9
Use Loctite 243 on the threads and apply activator.
10 Insert the connector.
11 Tighten the connector to 10 Nm.
12 Install the crimp terminals in the receptacle according to the cable drawing.
13 Put the battery and the PCB back in the tube.
14 Check and replace any damaged O-rings on the transducer before replacing it.
15 Connect the new connector and the transducer to the PCB.
16 Install the transducer.
30
110-0000612/A