After-Sale Services - Toto TLP02309 Operation Manual

●The following phenomena may occur but they are not due to any trouble.
Phenomena
Handle operation is This is due to the fact that the parts inside the
heavier that when first product fit each other well and become stable
using the product. during use. This is not due to any trouble.
Tip
Fitness of parts (Ceramic valves)
When you move the handle up and down or to the right and left, parts A and
B shown in the figure rub against each other.
When first using the product, since the
indents are minute and the friction area
is very small, both parts readily move.
The indents are worn and the friction
area becomes large. Therefore, a force
somewhat stronger than when first
using the product is needed.
Change of operation force
Period of use in a general family:
Half year ~ 2 years
Operation
force
When first using
the product:
Frequency of use
15
Explanation Ref. Page
—
A
B
A
B
Stable
Somewhat
light

After-Sale Services

1 1 2 2 2 3 3 3 4 4 4 5 5 5
Daily care and checking by customer
Date of
Replacement of consumable parts
installation
Replacement of worn and degraded parts Replacement of worn and degraded parts Replacement of worn and degraded parts
(Ask your dealer depending on the status of wear and degradation.) (Ask your dealer depending on the status of wear and degradation.) (Ask your dealer depending on the status of wear and degradation.)
[Before asking for repairs, please check "Troubleshooting" (Page 14).]
Replacement of part(s)
Parts and products that are dismounted for repairs belong to TOTO.
Years of use
6 6 6 7 7 7 8 8 8 9 9 9 10 10 10 11 11 11
Consideration
replacement
12 12 12
of
16