Troubleshooting - Toto TLP02309 Operation Manual

How to anchor the spout
Water leak around piping (More than twice a year)
No water
leaks
13
Hexagonal wrench
(Distance across
faces: 2.5 mm)
Check around piping for any
water leaks.
Part(s) may break due to deterioration or
wear, and you may be injured, and water may
leak, wet household articles and cause
damage to your property.
If water leaks, close the water shutoff valve
and the main valve (see Page 14) and ask
your dealer or seller for repair.

Troubleshooting

How to stop water in an emergency
In case of an emergency such as leaking water around the
piping or water does not stop flowing, close the water shutoff
valve or the main valve as shown in figure below.
Main valve
Main valve
●The following phenomena are not troubles. Before asking for repairs, check
the following points. If the troubles persist, ask your dealer for repairs.
For details, check the after-sale services (page 16).
Before asking for repairs
Phenomena Check Point
Is the lever handle lowered down to
Water does
the water stop position?
not stop.
(Is the water stop valve fully close?)
Is the water discharge port clogged?
If the single handle faucet is used in
The flowrate
combination with a gas water heater,
is too slow.
is the capacity set appropriately for
the capacity change type?
Only cold
Is a sufficient volume of hot water
water comes
coming from the water heater?
out.
Is a sufficient volume of hot water
Temperature
coming from the water heater?
cannot be
adjusted
Is the water discharge port
well.
clogged?
Lever handle
Is the screw that anchors the
is loose. lever handle loose?
Only cold water
Is the lever handle turned to the
left side of center?
comes out.
Ref.
Remedy
Page
Lower the lever handle down
Page 7
to the water stop position.
Clean the water discharge port. Page 9
Set the appropriate
—
capacity.
Check the water heating
—
temperature and the
operation of the water heater.
Check the water heating
—
temperature and the
operation of the water heater.
Clean the water
Page 9
discharge port.
Retighten the loose screw. Page 12
Turn the lever handle to
Page 6
the left side.
14