Table Of Content PART 1: SAFETY WARNINGS Electrical Shock Hazard And Cut Hazard Important Safety Instructions Operation And Maintenance Electrical Shock Hazard Health Hazard Hot Surface And Cut Hazard Important Safety Instructions PART 2: NAME OF PARTS PART 3: INSTALLATION Before Locating The Fixing Brackets Easy Fit kits Fix Clips To Hob:...
Page 3
Stop & Go function Activate Stop & Go function Deactivate Stop & Go function Using The Timer Time Overview Using The Timer As A Minute Minder Setting The Timer To Turn Cooking Zone Off Detection of Pan and Small Articles Residual Heat Warning Auto Shutdown Over-heat Protection...
Do not cook on a broken or cracked hob. If the hob surface should break or crack, switch the appliance off immediately at the mains power supply (wall switch) and contact MODENA technician. • Switch the hob off at the wall before cleaning or maintenance.
• Operation And Maintenance Electrical Shock Hazard Electric cooker MODENA is specifically designed for long-term use so it does not require complex maintenance. However, there are some things that are recommended to treat your electric stove so that the quality of the stove is maintained.
• Do not repair or replace any part of the appliance unless specifically recommended in the manual. All other service should be done by MODENA technician. • Do not use steam cleaner to clean hob. •...
Page 7
• If the power supply cable is damaged, it must only be replaced by MODENA technician. • This appliance is intended to be used in household and similar applications such as: -staff kitchen areas in shops, offices and other working environments;...
PART 2: NAME OF PARTS BC 1640 LAM 1. 1200W Cooking Zone 2. 2200W/1100W Dual Cooking Zone 3. 1800W Cooking Zone 4. 1200W Cooking Zone 5. Glass plate 6. Control panel Control Panel 1. Extended zone control button 2. Cooking Zone selection button 3.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant work surface material to avoid larger deformation caused by the heat radiation from the hotplate. As shown below: Model BC 1640 LAM 555+5- 495+5- 50 min NOTE: The safety distance between the hotplate and the cupboard above the hotplate should be at least 760mm.
A (mm) B (mm) C (mm) 760 mm 50 mm minimal 20 mm minimal Air Intake Air exit 5 mm Before Locating The Fixing Brackets The unit should be placed on a stable, smooth surface (use the packaging). Do not apply force on to the controls protruding from the hob.
Technician. NOTES: • If the cable is damaged or needs replacement, this should be done by MODENA technician using the proper tools, so as to avoid any accidents. • If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker must be installed with a minimum gap of 3mm between the contacts.
Installing The Electric Cooker On Kitchen Set Table The connection method shown below: CAUTION: 1. The hob must be installed by MODENA technicians. Please never conduct the operation by yourself. 2. The electric hob shall not be mounted to cooling equipment, dishwashers and rotary dryers.
PART 4: HOW TO USE Before Using Your New Hob • Read this guide, taking special note of the Safety Warning section. • Remove any protective film that may still be on your new electric hob. Using The Touch Controls •...
• Induction hob are made from smooth, ceramic glass, the heat comes from a magnetic induction coil which heats the cook ware but not the cooking surface. The heat from the cook ware is transfer red to the food. • It’s important that you use only metal pans specifically designed and/or approved for use on induction hobs.
The heat setting indicator of the selected zone flashing when be active, then you could adjust its heat level by below: - Touch control model of BC 1640 LAM A. Set heat setting by touching the button B.
NOTES: 1. After connected to electricity, when power on, the buzzer of hob beeps once, all indicators light on for 1 second then off. 2. When the hob in Standby mode, if there is no practice within 1 minute, the electric hob will auto turn off, with buzzer beeps once.
To use Extended zone when hob is working, follows below: Select and active the cooking zone which you would like to use extended zones, for those cooking zone with this feature.Touch the heating zone selection control button to select and active it for adjustment. 2.
• When the controls are locked, except the ON/OFF control button and Child Lock control button, all other touch control buttons are disabled. To Lock The Controls Touch the Child Lock control button once. The timer indicator will show “Lo“, and Child Lock function is activated. To Unlock The Controls 1.
• The Stop & Go function can turn off all zones. When you back, with one more touching of the button , hob restarts where they were, to carry on cooking. Activate Stop & Go function To active Stop & Go function, you can press the Stop & Go function button once.
2. Then adjust Minute Minder setting follows below: 1) Touch control models: BC 1640 LAM • Set heat setting by touching the plus or minus button. If press and hold either of the two buttons, the value will adjust down or up rapidly in circle.
2. Touch the timer control button , the number in timer indicator flashing. 3. Then adjust timer setting 1) Touch control models: BC 1640 LAM • Set heat setting by touching the plus or minus button. •...
When the timer is set, it will begin to count down immediately, the display will show the remaining time NOTES: • The red dot next to power level indicator will illuminate for those zones be set with timer. You can check timer setting of different cooking zone which set with timer, by activate this cooking zone.
NOTES: • No heating takes place unless there is a suitable pan on the cooking zone. • The hob will auto turn off after 2 minutes if no suitable pan is placed on it. • When an unsuitable size or non-magnetic pan (e.g. aluminum), or some other small item (e.g.
invalid except ON/OFF and Child Lock button, unless you wipe the touch control area dry. Cooking Guidelines Cooking Tips • When food comes to the boil, reduce the power setting. • Using a lid will reduce cooking times and save energy by retaining the heat.
4. Turn the steak only once during cooking. The exact cooking time will depend on the thickness of the steak and how cooked you want it. Times may vary from about 2 – 8 minutes per side. Press the steak to gauge how cooked it is –...
PART 5: MAINTENANCE The MODENA Electric cooker is designed specifically for long term usage and does not require complicated maintenance. However, there are several advices on how to maintain the quality of your stove. Glass/Ceramic Surface • Clean the dirty part of the glass / ceramic using a wet cloth or a special glass / ceramic cleaner, and then dry it using a fine cloth.
PART 6: TROUBLESHOOTING Problem Possible Cause Recommended Action • When turn off the power supply of hob, there will be no ‘hot surface’ indication but the cooking zone may still be • Switch off the power supply. Everyday soiling hot! Take extreme care. •...
Page 29
Problem Possible Cause Recommended Action • Switch power supply. • • The hob may beep and turn It Soak up the spill self off, touch • Wipe the touch control area controls may not function Spillovers on the with a clean damp sponge while there is liquid on them.
Page 30
- This is normal, this is to help appliances completely cool down. 5. Some pans make crackling or clicking noises during use of induction hob: - This is normal, it’s the sound of induction coils during working, and for different construction of your cookware, the clicking might be slightly different.
PART 7: SPECIFICATION MODEL BC 1640 LAM Type Vitroceramic Hob Number of burners Ø200 mm (1800 W) x 2 Ø165 mm (1200 W) x 1 Burner composition Ø138 - 230 mm (1100/2200 W) x 1 Blocking securing system Color Black...
Need help?
Do you have a question about the BC 1640 LAM and is the answer not in the manual?
Questions and answers