Brother PJ-822 User Manual page 62

Fixed Page
Paper is fed at the end of a job to suit the vertical length of the selected page size (for example: letter,
legal, A4, or user-defined size). Select this setting when using roll paper. Make sure to set Paper Type to
Roll.
End of Page
Paper is fed until the paper sensor detects a pre-printed end-of-page mark on the paper or the end of the
sheet, or until 14" (355.6 mm) of paper has been fed. Use this setting when Paper Type is set to Cut
Sheet or Perforated Roll.
End of Page Retract
Paper is fed until the paper sensor detects a pre-printed end-of-page mark on the paper. Then, the paper
is fed back to the starting position before the next page is printed. Use this setting when Paper Type is set
to Perforated Roll.
5. Feed Margin
Specify the feed margin of the print job. Use this setting when Form Feed Mode is set to No Feed/Feed
Margin.
6. Feed Position
Specify the paper feed position for printing on custom paper.
7. Multiple Page
Select to print more than one page on a single sheet of paper.
8. Page Order
Specify the page order when a setting other than Normal is specified for Multiple Page.
9. Border Line
Specify the border line between pages when a setting other than Normal is specified for Multiple Page.
Advanced Tab
1. Density Adjustment
Select the printing density.
2. Scaling
Specify the reduction or enlargement ratio for printing.
3. Mirror Print
Select to print your document in reverse.
4. Reverse Print
Select to rotate your document 180 degrees.
1
2
3
4
5
6
7
8
58