Pairing - HomeMatic HmIP-BSM-I Installation And Operating Manual

• Place a suitable adapter on the switch module and screw it tight
using the enclosed screws (see figure 6). For further details on
installation, refer to the operating instructions for the adapter.
• Connect the Switch Module as required according to figure 3, 4
or 5.
• Loosen the screws of the flush-mounted box and screw the box
slightly outwards.
• Insert the Switch Module with the mounted adapter onto the
screws in the flush-mounted box and screw the screws back in
(see figures 7+8).
• Place the frame of your switch series on the Switch Module (see
figure 9).
• Insert the rocker into the frame (see figure 10).
• Switch the circuit breaker of the power circuit back on again.
• The Switch Module is now ready for operation and can be con-
nected to the Homematic IP access point (see see „6.4 Pairing"
on page 35).
6.4

Pairing

Please read this entire section before starting the pairing proce-
dure.
First set up your Homematic IP access point via the Homematic IP
app to enable operation of other Homematic IP devices within your
system. For further information, please refer to the operating manu-
al of the access point.
You can connect the device either to the access point or to the
Homematic Central Control Unit CCU3. For detailed information,
please refer to the Homematic IP User Guide, available for download
in the download area of www.homematic-ip.com.
To integrate the device into your system and enable it to communi-
cate with other Homematic IP devices, you must first add the device
to your Homematic IP access point.
Start-up
35