Led Status Indicators - LaCie 301382U User Manual

LaCie 2big Quadra Enterprise Class
User Manual

4.1. LED Status Indicators

Use the 2big's front and rear LEDs and the chart below as a reference to determine the status of your 2big:
If the front And the rear LED
LED is:
Solid blue
Blinking blue
Dimming blue (5s)*
One disk is blinking
blue, while the other
disk is blinking 3
Alternating long blue
and short red:
Solid red (failed
disks) and solid blue
(functional disks)
Solid red (failed
Solid red
disks) and solid blue
(functional disks)
Blinking blue/red
Normal LED activity
Dimming red (5s)*
Dimming red (5s)*
Off
* LED dims for 5 seconds and then remains at a low intensity.
• D
And the RAID
is: mode is:
Blinking blue
All
Blinking blue
All
Off All
Safe
blue, 1 red:
Mixed
Safe
Mixed
All
All
Off All
Off All
Off All
n P
esign by eil oulton
Then:
The 2big is working properly, only active disks' LEDs blink.
The 2big is starting up; front LED and LEDs of functional disks become
solid blue when initialized.
The 2big is in standby mode. If the power switch is set to "auto" the
2big will enter standby when your computer is either off or in standby.
If rebuilding has begun, the process will finish before the 2big can
enter standby. After 30 minutes of standby, the LED will switch off.
RAID is rebuilding.
One drive has failed or was improperly inserted; RAID is functional but
the security of the drives has been compromised.
One or more drives have failed or are improperly inserted; RAID is not
functional.
Temperature alert; allow the 2big to finish current processes and then
shut it down. Make sure the ventilation holes on the back of the 2big
are not obstructed and that there is ample room for airflow around the
unit. Allow the 2big to cool before turning it back on.
During standby mode, when one or more drives have failed or are
improperly inserted; RAID is not functional. Dimmed LED stays on for
30 minutes.
Temperature critical; LaCie recommends that following this event
you leave the 2big in standby for at least an hour before restarting to
prevent damage to the disks.
The 2big is either turned off, or has been in standby mode for more than
30 minutes, or system or electronic board failure; in this case, contact
LaCie customer support.
Troubleshooting
page 26