Advertisement
P OW ER U P
1. Select Time Zone and DST settings.
2. Insert one, two, or three batteries into the Battery
Compartments.
3. The hands will move to the 12 o'clock position and search
for the WWVB Atomic Time Signal for up to 10 minutes.
• If no signal after 8-10 minutes, the clock will run from 12:00.
• Allow up to 5 nights to receive this transmission, the clock
will continue to search for the WWVB signal on its own.
4. For the best reception, place the clock on an exterior
wall near a window with the front or back of it facing Fort
Collins, CO.
Watch the setup video:
bit.ly/wallclock_setup
Note: In certain areas, this clock may not be able to receive
the WWVB reception due to signal strength or interference.
In this case, your clock can be set manually until the Atomic
Time Signal can be received.
MA NUALLY S ET TIM E
Hold the SET button for about 3 seconds.
• Press & Hold SET to move hands quickly.
• Press & release SET to move hands step by step.
Note: The Atomic Time Signal will override manual settings.
Reset: If the clock does not respond when trying to manually set
your time, press the RESET button.
Page | 2
4
1
2
+
3
4
AA
+
5
6
SPECI FICATIONS
Battery Requirement: 1 AA (IEC LR6) in any compartment.
Not Included.
Battery Life:
1 Battery: Up to 2 years
2 Batteries: Up to 4 years
3 Batteries: Up to 6 years
Dimensions: 16" Diameter
JO I N T HE C O NV E RSAT I O N
Ask questions, watch detailed setup videos, and provide feedback
on our social media outlets!
1
SET
2
WAVE (Atomic search)
4
3
RESET
4
Battery Compartment
+
5
Time Zone Selector
6
Daylight Saving
Time Selector
Page | 3
Advertisement
