Existing Construction Installation Instructions - Utilitech 7105-08-L Manual

NEW CONSTRUCTION INSTALLATION INSTRUCTIONS (Continued)
8. Attach grille (B) by pinching the mounting springs and
inserting them into the narrow rectangular slots in the
fan housing (A).
Turn on power source. Test the unit.
9. If desired, the trim finish can be changed. To change the trim,
pull down gently from each side to release the magnetic
attachment. Place an alternate grille trim piece (D) around the
grille with LED light (B) until the magnetic attachment is
secure.

EXISTING CONSTRUCTION INSTALLATION INSTRUCTIONS

BEFORE INSTALLATION
WARNING: RISK OF ELECTRIC SHOCK! Ensure the
electricity to the wires you are working on is shut off.
Either remove the fuse or turn off the circuit breaker
before removing the existing bath fan or installing the
new one.
1. Remove existing fan.
2. Measure the opening to ensure it is large enough to
accommodate the 7-1/2 in. x 7-1/4 in. dimensions of
the new fan housing (A).
8
Mounting
springs
9
D
1
2
7
Alternate trim finish
A
Housing
slots
B
B