Table of Contents
Advertisement
Proceed as follows:
1. Using the drilling template in the Appendix of this
manual, mark the wall for the wall plugs. Refer also
to the Mechanical Details drawing in the datasheet
supplied with the loudspeaker. Check the dimensions
given from the reference datum to each pair of
mounting holes, and allow for the offset of the acoustic
centre from the reference to ensure that the acoustic
centre will be at the height defined in the acoustic
design specification. Reference to Fig.16 may also be
helpful. Drill the holes (Ø 10 mm).
2. Insert the plugs and screws into the holes. Tighten the
screws with a spanner, but stop with a few mm of screw
shaft visible between the head and the wall.
3. By removing the mounting plate of one bracket, check
to ensure that the mounting screws are sufficiently
spaced from the wall.
4. Check that the chosen mounting points will position
the column in the correct vertical angle specified by the
acoustic design (which is usually exactly perpendicular
to the listening area). Use spacers on one or more of the
brackets if necessary.
20
JBL
Intellivox HP series Installation Manual Rev 2.1
®
5. Lift the Intellivox and slide the brackets over the heads
of the hex-head screws protruding from the wall.
6. Firmly fasten the screws securing the brackets to the
wall. Re-check the verticality (or other angle if specified)
with a spirit level or similar levelling device.
7. Remove hinge bolts from one side of brackets to allow
rotation and access to the rear of the unit. Install all
connections as described in 'Connector and Wiring
Details'. Reinstall hinge bolts to secure unit in place.
The unit should not be powered during
installation. The connector bay contains live
parts and should only be opened if the
mains power has been disconnected.
202007/IvxHPIM_v2.1
Advertisement
Table of Contents
