Table of Contents
Advertisement
Connecting the TV to a SBB or STB
STB (SBB)
ETH MODEM
Connect the DATA port of the TV to the ETH MODEM port of the STB (SBB) with the Data cable.
• The ETH MODEM port name that you connect the Data Cable to may differ depending on the SBB or STB type.
• IR signals sent by the remote control to the TV or SBB / STB must meet the following specification to use IR pass
through function.
IR signal reciever specification
– Band pass filter centre frequency: 37.9 ㎑
– Carrier Frequency, Duty 50%
– Minimum Burst Length (tburst): 12 pulses (316 us)
– Minimum Gap Time Between the burst (tburst gap): 16 pulses (422 us)
– Minimum Gap Time between the data commands (tpause): 25 ㎳
Data Cable
English - 27
TV Rear Panel
Advertisement
Table of Contents
