Table of Contents
Advertisement
Connecting the TV to an SBB or STB
STB (SBB)
ETH MODEM
Connect the DATA jack of the TV to the ETH MODEM jack of the STB (SBB) with the Data cable.
• The ETH MODEM jack name that you connect the Data Cable to may differ depending on the SBB or STB type.
• The remote control IR signal need to meet the following specification to use IR pass through function.
IR signal reciever specification
– Band pass filter centre frequency: 37.9 ㎑
– Carrier Frequency, Duty 50%
– Minimum Burst Length (tburst): 12 pulses (316 us)
– Minimum Gap Time Between the burst (tburst gap): 16 pulses (422 us)
– Minimum Gap Time between the data commands (tpause): 25 ㎳
Compatible Data Cables Supplied with the TV
• Confirm you are using the correct data cable for your vendor. Refer to the code label on the data cables.
6
STB SIDE
1
CON A
CON A
6: NC
5: IR
4: GND
3: Rx
2: Tx
1: Nc
• Operation Specification of Data Cable(RJ12) : RS232
Data Cable
CON A
CON B
5
4
3
2
English - 25
CON B
6
2
5
3
TV Rear Panel
1
TV SIDE
6
CON B
1: NC
2: GND
3: Tx
4: NC
5: Rx
6: IR
Advertisement
Table of Contents
