NTI VOPEX-2P Installation Manual

NTI
R
NETWORK
TECHNOLOGIES
INCORPORATED
INSTALLATION GUIDE FOR THE
VOPEX-2P
Keyboard, Video, and Mouse Splitter
MAN052 Rev Date 10/1/2002

Materials included with this kit:

•
VOPEX-2P KVM Splitter Unit
•
VEXT-6 6' VGA Monitor cable
•
Two VKINT-6-MM 6' Keyboard and Mouse Cables

INTRODUCTION

The VOPEX-2P KVM Splitter enables the control of one PS/2 CPU through two separate PS/2 keyboards, mice, and VGA monitors. Each user is
able to have complete control of a CPU, provided they don't try to access it at the same time. While the user access is controlled by four (4)
separate modes of operation, both user monitors will show the same image at all times.

LIMITATION

•
Does not support hot-plugging of devices.

INSTALLATION

First
Turn OFF power to CPU and monitor(s).
Monitor Connection
1. Disconnect the monitor cable at the CPU and reconnect it to MONITOR 1 port on the rear of the VOPEX-2P.
2. Connect the male 15HD connector end of the VEXT-6 into the CPU's video port.
3. Connect the female 15HD connector end of the VEXT-6 into the VIDEO CPU port on the front of the VOPEX-2P.
4. Plug a second monitor (or optional VEXT-xx extension cable) into MONITOR-2 port on the rear of the VOPEX-2P.
Note: "xx" in VEXT-xx indicates the length of the cable in feet. Many lengths are available. Contact your NTI salesperson or visit us at
our website at http://www.nti1.com for details.
Mouse Connection
1. Disconnect the mouse at the CPU and reconnect it to MOUSE 1 port on the rear of the VOPEX-2P.
2. Connect one male 6 pin miniDIN end of a VKINT-6-MM cable into the mouse port on the CPU.
3. Connect the other male 6 pin miniDIN connector of the same cable to MOUSE CPU port on the front of the VOPEX-2P.
4. Connect a second mouse (or optional PS/2 extension cable VKEXT-xx) to MOUSE 2 port on the VOPEX-2P.
5. Disconnect the keyboard at the CPU and reconnect the keyboard to KEYBOARD 1 port on the rear of the VOPEX-2P.
Keyboard Connection
1. Connect one male 6 pin miniDIN end of the second VKINT-6-MM cable to the keyboard port on the CPU.
2. Connect the other male 6 pin miniDIN connector of the same cable to KEYBOARD CPU port on the VOPEX-2P.
3. Connect a second keyboard (or optional PS/2 extension cable VKEXT-xx) to KEYBOARD 2 port on the VOPEX-2P.
Power-Up
Turn ON power to CPU and monitors.

SPECIFICATIONS

Size: Each unit is 4.25" x 5.25" x 1.6"
Power: Powered by connected CPU
Connections: 15HD VGA & SGA compatible
6 pin miniDIN keyboard and mouse connectors
1275 Danner Dr Tel:330-562-7070
Aurora, OH 44202 Fax:330-562-1999
www.nti1.com
1
VGA
Multi-Scan
Monitor
VOPEX-2P
VGA
Multi-Scan
Monitor