Electricity Supply; Fuel Supply - Jobsite CT2142 Original Instructions Manual

The electrical system to which the appliance is connected must comply with
current legislation. Installation requires a residual current circuit breaker
(rccb) in the main electrical distribution board.
Unplug the appliance before performing any maintenance operations.
Always check the power cable before using the appliance. It must not be
bent, taut, stretched, crushed or any way damaged.
The power cable must be replaced by qualified personnel only. Use an
original power cable only with a 3-pin approved plug.
The front outlet is very hot during operation. Do not touch! Burn danger.

ELECTRICITY SUPPLY

This range of heaters is designed to run off 220‐240V 50Hz electrical supply.
WARNING: This appliance must be earthed.
Note: If the Plug needs to be replaced to suit local requirements a qualified
electrician should carry out the replacement taking care to earth the unit and
maintain the correct phase connection as per the wiring diagram.

FUEL SUPPLY

Please only use the following fuel types in the heater: Kerosene or Diesel with
viscosity t.
WARNING: Under no circumstances should any other fuel type be used. Do not
fill the fuel tank while the heater is running.
6