Selecting additional settings
Now touch the or sensors to se-
lect:
0: keypad tone off; door alarm off
1: keypad tone off; door alarm on
(after 4 minutes)
2: keypad tone off; door alarm on
(after 2 minutes)
3: keypad tone on; door alarm on
(after 2 minutes)
Touch the OK sensor to confirm the
selection.
The selected setting is applied; the
symbol flashes.
Touch the settings sensor to exit set-
tings mode.
If you do not do this, the appliance
electronics will exit settings mode au-
tomatically after approximately
1 minute.
28
Display brightness
You can adjust the brightness of the
display to suit the ambient light condi-
tions in the room.
The display brightness can be adjusted
incrementally from 1 to 3. The factory
default setting is 3 (maximum bright-
ness).
Changing the brightness of the dis-
play
Touch the settings sensor.
All symbols available for selection will
appear in the display and the sym-
bol flashes.
Touch the sensors for setting the
temperature ( or ) repeatedly until
the symbol flashes in the display.
Touch the OK sensor to confirm your
selection.
The last selected setting flashes and
the symbol lights up in the display.