D-Link DIR-842 User Manual page 77

DIR-842 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh Gigabit
Router
User Manual
Figure 67. The Connections Setup / WAN page. The advanced mode.
To create a new connection, click the ADD button (
that the connection creation page opens.
To edit an existing connection, in the Connections List section, left-click the relevant line in the
table. On the opened page, сhange the needed parameters and click the APPLY button.
To disconnect a connection and establish it again, select the checkbox located to the left of the
relevant line in the table and click the RECONNECT button.
To remove a connection, in the Connections List section, select the checkbox located to the left
of the relevant line in the table and click the DELETE button (
To allow multicast traffic (e.g. streaming video) for a connection, click the IGMP/MLD link (for the
description of the page, see the IGMP/MLD section, page 161).
To use one of existing WAN connections as the default IPv4 or IPv6 connection, in the Default
Gateway section, select the choice of the radio button which corresponds to this connection.
To return to the simplified mode, click the SIMPLIFIED MODE button (the button is unavailable if
several WAN connections are created).
) in the Connections List section. Upon
Page 77 of 233
Configuring via Web-based Interface
).