D-Link DIR-842 User Manual page 157

DIR-842 AC1200 Wave 2 MU-MIMO Wi-Fi EasyMesh Gigabit
Router
User Manual
In the opened window, you can specify the following parameters:
Parameter
Enable
Protocol
Interface
Destination network
Destination netmask
Gateway
Metric
Table
After specifying the needed parameters, click the SAVE button.
To edit an existing route, select a relevant line of the table. In the opened window, change the
needed parameters and click the SAVE button.
To remove an existing route, select the checkbox located to the left of the relevant line in the table
and click the DELETE button (
Move the switch to the right to enable the route.
Move the switch to the left to disable the route.
An IP version.
From the drop-down list, select an interface (connection) through
which the device will communicate with the remote network. If you
have selected the Auto value, the router itself sets the interface
according to the data on the existing dynamic routes.
A remote network which can be accessed with help of this route. You
can specify an IPv4 or IPv6 address.
The format of a host IPv6 address is 2001:db8:1234::1, the
format of a subnet IPv6 address is 2001:db8:1234::/64.
For IPv4 protocol only.
The remote network mask.
An IP address through which the destination network can be accessed.
A metric for the route. The lower the value, the higher is the route
priority. Optional.
From the drop-down list, select a routing table for the route.
group_1 table is used to route user traffic.
•
main table is used to route management traffic from internal
•
system services of the router.
).
Page 157 of 233
Configuring via Web-based Interface
Description