Timer Mode - Clifford Matrix RSIII Owner's Manual

➜

timer mode

Timer Mode automatically starts your vehicle engine and runs it
for a pre-programmed time period, every three hours for a total
of six operation cycles. Timer Mode helps to ensure that your
engine will start in the morning after being parked outside
during a night of extremely cold temperatures.
important! ! This feature must only be used in open areas,
never in an enclosed area such as a garage.
To enter Timer Mode:
1. Start the vehicle by pressing and releasing
the remote control.
2. Press and release
3. Within two seconds, press and release
remote control again.
4. The engine will shut down and the parking lights will flash
four times. The engine will then restart to confirm that
Timer Mode has been entered.
The vehicle engine may be allowed to run for its pre-programmed
time period, or it can be shut down while running during Timer
Mode operation by pressing buttons
control again. In either case, the vehicle will restart every three
hours for a total of six operation cycles. If the system receives a
shut-down input while the engine is running in Timer Mode, the
engine will stop, but will restart, on schedule, again in three hours!
© 2002 directed electronics, inc.
and
on the remote control.
and
and on the remote
on
on the
31