Table of Contents
Advertisement
CARE AND MAINTENANCE
Storage
Store the Jump-Starter at room temperature. Make sure the battery clamps are stored on the
appropriate case clamp posts on the side of the unit after use.
Due to inherent self-discharge, lead acid batteries should be charged at least every
4 months, especially in a warm environment. Leaving a battery in a discharged state, or if not
recharged every 4 months, may result in permanent battery damage and poor jump-starting
performance.
Battery Replacement / Disposal
The Jump-Starter is designed to provide years of service. However, when the internal battery reaches
the end of its service life, the Jump-Starter itself is no longer of use. The internal battery is not
designed to be user replaceable.
Because the internal battery contains lead, the Jump-Starter should be recycled or
safely disposed of at a local recycling center. Examples of places that will accept items
like this are: county or municipal recycling drop-off centers, scrap metal dealers and
retailers who sell automotive replacement lead-acid starter batteries.
Contains sealed lead-acid battery. Battery must be recycled. Wash hands
thoroughly after handling battery.
Pb
FCC INFORMATION
This product complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
This product has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
9
Advertisement
Table of Contents
