Troubleshooting; Care And Maintenance; Storage; Fuse Replacement - Peak PKC0LS Owner's Manual And Warranty Information

LED Flashlight Operation
1. Press the LED flashlight switch once to turn on the LED flashlight. It will remain a steady beam.
2. Pressing the switch a second time will change the steady beam to a strobe light.
3. Pressing the switch a third time will make the light flash the SOS signal.
4. Pressing the switch a fourth time will turn OFF the LED flashlight.

TROUBLESHOOTING

Problem Situation
No voltage at Low voltage shutdown
jumper cables or
Overload protection
green jump starter
Short circuit protection
power LED is not lit
Red incorrect Incorrect connection
connection LED
is lit and alarm
sounds
Alarm sounds Low voltage

CARE AND MAINTENANCE

Storage

Store the Jump-Starter at room temperature. Make sure the battery clamps are stored properly.
For best performance, the Jump-Starter should be fully recharged every 6 months.
Typical charge time is 5-6 hours. Poor jump-starting may result if not fully recharged every 6
months.

Fuse Replacement

1. Turn the cap on the tip of the power plug counterclockwise.
2. Remove the cap, center pin and fuse.
3. Replace the fuse with a new 2-amp fuse.
4. Replace the center pin and cap. Turn the cap clockwise.
Battery Replacement / Disposal
The Jump-Starter is designed to provide years of service. However, when the internal battery reaches
the end of its service life, the Jump-Starter itself is no longer of use. The internal battery is not designed
to be user replaceable.
The Jump-Starter contains a lithium cobalt battery. The Jump-Starter should be recycled
or safely disposed of at a local recycling center. Examples of places that will accept items
like this are: county or municipal recycling drop-off centers, scrap metal dealers and
retailers who sell replacement lithium ion batteries.
Li+

SPECIFICATIONS

1. Built-in battery Lithium cobalt
2. USB power outlet 5 volts/2.1 A
3. LED flashlight One LED
4. Charging time 5-6 hours
5. Charging temperature 32°F-104°F (0°C-40°C)
6. Storage and operating 14°F-113°F (-10°C-45°C)
temperature
Action
Charge battery and press reset button
Press reset button
Correct jumper cables correctly
Charge battery and then press reset button
7