Worklight Operation; Troubleshooting; Care And Maintenance; Storage - Peak PKC0AZ Owner's Manual

Worklight Operation

Simply turn the worklight ON/OFF switch (on the front panel) to the ON position.
The worklight will operate.
Turn o when not in use.

TROUBLESHOOTING

Problem Situation
Vehicle does not Improper cable clamp
start connections
Very low vehicle battery
charge
Low battery charge on
Jump-Starter
Vehicle battery defective Replace with a new battery.
Accessory device No ouput power at 12-
connected to volt DC power socket
12-volt DC power
Bad accessory plug
socket or USB
connection at the
power outlet does
12-volt DC power
not operate
socket
Low battery charge on
Jump-Starter

CARE AND MAINTENANCE

Storage

Store the Jump-Starter at room temperature. Make sure the battery clamps are stored on the
appropriate case clamp posts on the back of the unit after use.
Due to inherent self-discharge, lead-acid batteries should be charged at least every
4 months, especially in a warm environment. Leaving a battery in a discharged state, or if not
recharged every 4 months, may result in permanent battery damage and poor jump-starting
performance.
Battery Replacement / Disposal
The Jump-Starter is designed to provide years of service. However, when the internal battery reaches
the end of its service life, the Jump-Starter itself is no longer of use. The internal battery is not
designed to be user replaceable.
Because the internal battery contains lead, the Jump-Starter should be recycled or safely
disposed of at a local recycling center. Examples of places that will accept items like this
are: county or municipal recycling drop-o centers, scrap metal dealers and retailers who
sell automotive replacement lead-acid starter batteries.
Contains sealed lead-acid battery. Battery must be recycled. Wash hands
thoroughly after handling battery.
Pb

SPECIFICATIONS

1. Built-in battery 12-volt DC, rechargeable, sealed, lead-acid AGM (Absorbed Glass Mat)
battery
2. 12V power socket 12-volt DC, 10-amp maximum
3. USB power outlet 5 volts/1000 mA maximum
4. Worklight Five non-replaceable LEDs
5. Charging time AC charging – maximum and initial charge time 36 hours;
typical charge time 18 to 24 hours
Action
Rotate the cable clamps back and forth to make a
good connection.
Wait 3 to 4 minutes before starting vehicle again.
Fully recharge Jump-Starter.
12V DC Power & USB ON/OFF switch still in the OFF
position. Turn 12V DC Power & USB ON/OFF switch on.
Reinsert accessory plug into the 12-volt DC power
socket.
Fully recharge Jump-Starter.
7