Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Lofrans Royal LW250AN
Summary of Contents for Lofrans Royal LW250AN
- Page 1 Horizontal Windlasses INSTALLATION AND USER’S MANUAL Royal MADE IN ITALY...
-
Page 2: Safety Information
Follow these warnings carefully to used as mooring point. The load must - Anchor windlass complete resistance fixing point. Lofrans s.r.l. is a leader company in the avoid possible accidents or damages. always be held by a specific leat or - Drilling template... - Page 3 3 INSTALLATION 3 INSTALLATION 3.4 General requirements for 3.5 Prevention from electrolysis installation For aluminium boats, it is essential that In order to operate the anchor windlass the anchor windlass be insulated from correctly, it must be installed to meet the deck through a non-conductive the following conditions: gasket (not supplied).
- Page 4 4 USE OF THE WINDLASS 3 INSTALLATION 4.1 Lowering the anchor – Make sure that the clutch is 3.6 Installation tightened and then disengage the chain stopper or safety stops. –Place carefully the drilling template on the deck, by ensuring the –...
- Page 5 4 USE OF THE WINDLASS 4 USE OF THE WINDLASS 4.4 Use of the warping drum 4.2 Weighing the anchor The warping drum can be used regardless of the gipsy, to help the - Make sure that the clutch is well mooring manoeuvres.
- Page 6 4 USE OF THE WINDLASS 4.5 Notes for use During mooring, the load on the chain can be very high due to current, wind and waves. – By paying out the chain, it is necessary to manoeuvre so that the chain is laid down on the seabed without heaping on itself.
-
Page 7: Maintenance
5 MAINTENANCE USE OF THE YACHT (MONTHS) LESS THAN 2 FROM 2 UP TO 6 MORE THAN 6 CHARTER EVERY 3 MONTHS EVERY 6 MONTHS EVERY 12 MONTHS EVERY 24 MONTHS EVERY 36 MONTHS 5.1 Maintenance programme For obtaining the best performances and the utmost efficiency of the anchor windlass, it is necessary to follow strictly the maintenance programme... - Page 8 5 MAINTENANCE 5.2 Gipsy maintenance/replacement – By turning anticlockwise, remove the gypsy through the manoeuvre handle. – Slip off from the shaft the upper clutch cone, the gipsy, and the lower clutch cone. – Wash with running water. DO NOT USE WATER UNDER PRESSURE.
- Page 9 6 MAINTENANCE Motor Power MANUAL Vessel Lenght Heavy Duty (ft) Vessel Lenght Light Duty (ft) Power Supply Maximum linear Load/Pull (Kg) Maximum linear Load/Pull (lb) Maximum lift Load/Pull (Kg) Maximum lift Load/Pull (lb) Max Lift Working Load (Kg) Max Lift Working Load (lb) Max Line Speed (mt./min.) Max Line Speed (ft/min.) Line Speed (mt./min.)
-
Page 10: Part List
7 PART LIST... - Page 11 7 PART LIST...
-
Page 12: Technical Data
8 TECHNICAL DATA... -
Page 13: Drilling Template
9 DRILLING TEMPLATE Learn more about anchors and docking we have.