Table of Contents
Advertisement
# of
Factory
Feature
flicks and
setting
chirps
Add a New
Remote to
Channel 3
15
—
(silent
arm/disarm)
Add a New
Remote to
Channel 4
16
—
(optional
remote
accessory)
Add a New
Remote to
Channel 5
17
1sec.
(remote
controlled
valet mode)
Erase all
19
—
channels
To change the AutoArming feature from its factory setting of "on" to "off," you
would do the following:
Turn the ignition key to the ON position.
Flick the valet switch back and forth 4 times (stop when you hear the 4th chirp).
Wait 3 seconds. You will hear one more chirp to confirm that the AutoArming
setting is now off.
Turn the ignition off. That's all there is to it!
Adding new remote controls
For other drivers in your family, or if you wish to control Falcon II systems on your
other cars with the same remote control, you can buy additional remote controls
from any Authorised Clifford Dealer and program them into the system yourself.
Each Falcon II will respond to as many as four 4-button/12-channel Premier and/or
ACG remote controls. To add a new remote control to the system, use the
procedures noted in the User-selectable features section on pages 13-14.
Secondary
action
Press remote control button III
Press remote control button IV
With the red side switch in the
DOWN position, press button I
—
Programming Example
14
Program
completion
Result
confirmation
Buttons III/channel 3 code
3 chirps
of the new remote control
has been memorised
Button IV/channel 4 code
4 chirps
of the new remote control
has been memorised
Channel 5/remote valet code
5 chirps
of the new remote control
has been memorised
All channels have been
2 chirps
erased, program in new
remote control(s)
Advertisement
Table of Contents
