Assembly & Set-Up - Troy-Bilt Vortex 3090 XP Operator's Manual

Assembly & Set-Up
Contents of Carton
• One Snow Thrower
• One Chute Control Rod
• One Snow Thrower Operator's
Manual
Assembly
Remove all loose parts before assembling.
Handle Assembly
1. Place the shift lever in the Forward-6 position
2. Observe the lower rear area of the snow thrower to be sure
both cables are aligned with roller guides before pivoting
the handle upward. Pivot the handle upward. See Figure
3-1.
Figure 3-1
• Two Replacement Auger Shear Pins
• One Product Registration Card
NOTE: Make certain the cables are seated properly in the
roller guides. See Figure 3-2.
3. Secure the handle by tightening the plastic knob located
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
• One Chute Assembly
• One Engine Operator's Manual
Figure 3-2
3
7