Assembly And Set-Up; Contents Of Carton; Handle Assembly; Chute Assembly - Troy-Bilt storm 3090 Operator's Manual

Assembly & Set-Up

Contents of Carton

• One Snow Thrower
• One Snow Thrower Operator's
Manual
Assembly
Remove all loose parts before assembling.

Handle Assembly

1. Place the shift lever in the Forward-6 position
2. Observe the lower rear area of the snow thrower to be sure
both cables are aligned with roller guides before pivoting
the handle upward. Pivot the handle upward. See Fig. 3-1.
NOTE: Make certain the upper ends of each cable are
seated properly in its bracket.
Figure 3-1
3. Secure the handle by tightening the plastic knob located
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.

Chute Assembly

1. Remove cotter pin, wing nut and hex screw from chute
control head and clevis pin and bow-tie cotter pin from
chute support bracket. Position the chute over the chute
base. See Fig. 3-2.
2. Place chute onto chute base and secure chute control head
to chute support bracket with clevis pin and bow-tie cotter
pin removed earlier. See Fig. 3-3.
• Two Replacement Auger Shear Pins
• Hex Rod
Chute
• One Product Registration Card
• Chute Assembly
Chute Control Head
Chute Base
Figure 3-2
Figure 3-3
3
Chute Support
Bracket
7