Additional Components - Bosch Rexroth MAD Operating Instructions Manual

IndraDynA_ATEX
Additional designation label on
the ATEX motor
5.7

Additional Components

DOK-MOTOR*-IDYN*A*ATEX-IB02-D5-P
CE: CE symbol
0102: Code number of the test authority
Ex: ATEX symbol
II: Device Group II, which is suitable for all hazardous areas
except mines susceptible to firedamp
2G: Device Category 2: the device is suitable only for explosion-
endangered atmospheres that are caused by gas that can
occur occasionally
EEx: The European standard for explosion protection has been
applied
p: Ignition protection class p means that an explosion-endangered
atmosphere is kept away from the ignition source (EN 50016-2)
d: Ignition protection class d means that an explosion cannot
be transferred to the outside (EN 50018-1)
IIB: Explosion subgroup for certain gases and vapors
T3: The max. permitted surface temperature (inside and outside of
the device) is 155° C
TPS***: Motor registration number
Fig. 5-3: Designation of IndraDyn A motors in ATEX design
To operate a motor as part of an overall system within an explosion-
protected area, further components are necessary. Not all required
components are in the scope of delivery of Bosch Rexroth. Components
that are not available from Bosch Rexroth are signified as additional
components and have to be ordered by the manufacturer of the system.
An overall system mainly consists of:
Bosch Rexroth components
• MAD or MAF motors with ATEX design
• IndraDrive control device
• Connection Cable
Additional components of other manufacturers
• Scavenging equipment and monitoring unit with connection hoses,
accepted as an overall system and certified for the required
protection class.
• For MAF motors: External cooling system (liquid cooling) For
specification refer to the motor project planning manual
• For MAD motors: External cooling system (fan) For specification
refer to motor project planning manual and the following notes.
Operating Instructions
Typenschild2_ATEX.tif
5-5